24V 240LEDs/m smd 3528 led strip lights 

 Above products are non-waterproof (IP33) strips, we also have epoxy coated waterproof (IP65), silicone sleeve waterproof (IP67) and silicon sleeve with gel inside waterproof (IP68) strips. Please feel free to inquiry us.

FEATURES:
1. Wide applicability, easy to install and maintain, long lifespan.
2. Very flexible, easily be curved to any shape, various colors available.
3. Extremely luminous, with wide viewing angle.
4. Energy saving and environment-friendly.

CAUTIONS:
1. Linear separable LED strip on flexible printed circuit board with self-adhesive back.
2. Each unit of 3 LEDs can be cut out as a regular segment without damaging the rest ribbon.
3. The connector is being upgraded.
4. We will keep customers to be informed.

APPLICATION:
1. Indoor decoration lighting.
2. Large scale backlight.
3. Window display lighting.
4. Building contour decorative lighting.
5. Advertisement signs.

NOTE:
Prohibit using this product in excess of the operating voltage (DC24V) 5%.
Non-waterproof products and the working environment humidity is less than 60%.
Don’t add reverse voltage at both ends of the product.
No weights extrusion, excessive Meander.
Life span is 50000h.
Standard length: 5 meters/reel.

Connection Diagram

NOTES:
1. All dimensions are in millimeters.
2. Tolerance is ±0.25mm unless otherwise specified.
3. Specifications are subject to change without notice

Packing information

ASSEMBLY INFORMATION:
1. Solder connection should only be performed on designated solder pads(marked”+/-),During soldering, don’t exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
2. The smallest unit (50mm or 100mm-6LEDS) can be removed by cutting with scissors between the designated solder pads.
3. The mounting of the ribbon is facilitated by means of the double-sided adhesive on the back-surface of the ribbon, Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partied, the mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the ribbon is appropriately positioned, Press on the ribbon with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).
4. The minimum bending radius is 2cm. The ribbon may by bent over a smaller radius of the circuit board contain no Electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.

SAFETY INFORMATION:
1. The SMD light ribbon itself and all its components many not be mechanically stressed.
2. Assembly must not damage or destroy conducting paths on the circuit board.
3. Installation of LED modules (with power supplies) needs to be made with regard to all applicable electrical and safety standards. Only qualified personal should be allowed to perform installations.
4. Correct electrical polarity needs to be observed, Wrong polarity may destroy the ribbon.
5. Parallel connection is highly recommended as safe electrical operation mode, Serial connection is not recommended. Unbalanced voltage drop can cause hazardous overload and damage the ribbon.
6. Please ensure that the power supply is of adapter power to operate the total load.
7. When mounting on metallic or otherwise conductive surfaces, there needs to be an electrical isolation points between ribbon and the mounting surface.
8. Pay attention to standard ESD precautions when installing the ribbon.
9. Damaged by corrosion will not be honored as a materials defect claim, it is the user’s responsibility to provide suitable protection against corrosive agents such as moisture and condensation and other harmful elements.