20keys RGBW LED Strip Light RF Remote Controller for 3528 5050 SMD Flexible LED Ribbon

Notice:
Using the remote controller Please pull out the battery insulate tape before using.
The RF wireless remote signal can pass through some nonmetal barrier. For proper receiving remote signal, please do not install the controller in closed metal parts.

How to pair a new remote controller:
The remote controller and main unit is 1 to 1 paired as factory default. It’s possible to pair maximum 5 remote controllers to one main unit and each remote controller could be paired to any main unit.
User could pair a new remote controller to main unit by following two steps:
1). Plug off the power of main unit and plug in again after more than 5 seconds.
2). Press ‘COLOR ONLY’ and ‘color brightness plus’ key simultaneously for about 3 seconds, in time of 10 seconds after the main unit powered on.

Protection:
The main unit has full protection function for wrong wiring, output short circuit, overload and overheat. The controller will protect itself from damage at these extreme conditions and could automatically recover when working condition is good.
To avoid the protection, please ensure the LED fixtures are capable for constant voltage driving and in rated range, the cables are well connected and insulated. Also please install the controller with good ventilation and heat dissipation.

Specification:
Dynamic mode:34 modes
Static color:30 colors
PWM grade:4000 steps
White brightness grade:10 levels
Color brightness grade:5 levels
Speed grade:10 levels
Direct color select:6 direct keys
Overload protection:Yes
Overheat protection:Yes
Working voltage:DC 5-24V
Remote frequency:433.92MHz
Remote control distance:15m at open area
Rated output current:3×3.5A+7A
Controller dimension:87x24x15mm